SNM2500 N20 motor gripper Tutorial Leave a comment

blog, 未分类

1.Take out the parts shown in the picture

2.Install like a picture

3. Mounting screws

4.Mounting motor

5.Mounting claws

Prepare the screws and shims shown in the picture
Installed in the middle, 2 sides of the 2 sides should be placed a total of 4 pieces

6. As the picture shows

Need to put two screws into this part

7.

Follow the 1.2 steps, the finished product is as follows

8.Repeat the above steps to install the remaining paws

9.Prepare the copper column, the screw

Prepare these things and install them on 4 holes

9.1 Insert the screw into the hole first, then twist the copper column3

10.After the copper column is installed, prepare the following parts

finished

11.Finished map

Post Views: 91

bing

Leave a Reply

Your email address will not be published. Required fields are marked *

Translate »